some instructions

1 files changed, 37 insertions, 0 deletions

diff --git a/source/bookbinding/cartonnage/ink_drawers/index.rst b/source/bookbinding/cartonnage/ink_drawers/index.rst
index 6e86ab0..6058b37 100644
--- a/source/bookbinding/cartonnage/ink_drawers/index.rst
+++ b/source/bookbinding/cartonnage/ink_drawers/index.rst
@@ -18,6 +18,7 @@ You will need:
 * bookbinding board, 1 mm thick;
 * bookbinding cloth or cloth-like paper;
 * decorative paper such as that used for book end sheets;
+* narrow ribbon;
 
 plus
 
@@ -44,6 +45,42 @@ Cutting
 
 Cut all the pieces in the appropriate material.
 
+Drawers
+^^^^^^^
+
+Using contact glue attach the back side to the plate,
+
+then the two lateral sides
+
+and finally the front.
+
+Spread PVA on the bookcloth for the sides, put the drawer so that it is
+centered on the shorter side and wrap the bookcloth all around the
+drawer, keeping the join as close as possible to one of the back
+corners.
+
+Clip the corners of the bookcloth and let the excess adhere to the
+bottom and to the inside of the drawer.
+
+Spread PVA on the bookcloth for the bottom, put it on the bottom.
+
+Cut 5 cm of ribbon, fold it in half, and attach it with contact glue to
+the middle of the front of the drawer, extending from the edge by 1.25 cm.
+
+Spread PVA on the one of the wider side linings, put it in the back of
+the drawer, starting 2 mm from the top edge and extending on both sides.
+Repeat for the front of the drawer.
+
+Spread PVA on the narrower side linings, put them in the sides of the
+drawer, starting again 2 mm from the top edge.
+
+Spread PVA on the bottom lining, put it in the bottom of the drawer.
+
+Assemble the optional divider inserting each piece in the slots of three
+other pieces.
+
+Repeat for all other drawers.
+
 Structure
 ^^^^^^^^^