Pair of Pockets
===============
.. figure:: pair_of_pockets_patterned_cotton.jpg
:align: center
In the 18th and parts of the 19th century, pockets for women were an
accessory not attached to any garment, but tied around the waist and
worn under the skirt (the more modest and privacy-respecting way) or on
top of it (for convenience, usually done just by the working classes).
Beside being significantly bigger than what is usually found in modern
womenswear clothing (but not necessarily the ones found in the
ones from the 19th century), they have the advantage of not letting the
weight of the contents hang from the fabric of a garment, and thus they
are a good match to ligtweight skirts or ones made from knit fabric.
Or, since it's the 2020s and there is no sense of decency anymore :D one
can wear them on top of a pair of jeans, visible to anybody.
Historical pockets were quite diverse: a good overview of their history
is in :cite:`2019:pocket` (or a very short version in
:cite:`2021:vampockets`), and an internet search will get you lots of
historical examples to reproduce or take inspiration from, as well as
people who made their own pockets and publish instructions, some of
which are listed in the :ref:`pockets_see_also` section.
This is just one way to make a pair of pockets which works and is easy
enough to do; if you are so inclined the rabbit hole of historical
construction methods can offer you many hours of research and making.
I sew most of my pockets by hand, as it is a quick and easy project,
but machine sewing is also an option, especially for more modern
variants. To sew by machine, lockstitch where the instructions say to
backstitch, and topstitch instead of hem/applique-stitching.
Materials
---------
* Fabric: about 40 cm of strong cotton or linen;
* optional, about 40 cm of dense cotton or linen for a lining;
* 2.4 m edge binding (bias or straight);
* 1.5 m tape;
* sewing thread.
This is of course a great way to use scraps and leftovers, and if you
don't have enough fabric to make a pair there are plenty of historical
examples of single pockets mounted on a tape of their own.
For the edge binding you can use finished tape, folded in half, or
strips of fabric, cut either on the straight grain (generally more
historically accurate) or the bias, folded in half and with the raw
edges folded towards the inside.
For the tape that runs around the waist you can use finished tape, or
fabric folded like the edge binding.
Pattern
-------
The pattern for these pockets is a vaguely pear shaped bag with a slit
in the top half of the front, often more than 40 cm deep. If you're not
reproducing an existing pocket you may want to download my own pattern,
which has the width and height of a B4 sheet and is on the smaller end
of typical historical sizes:
:download:`pockets_B4.svg`
SVG source, can be scaled to taste;
:download:`pockets_B4-A4.pdf`
PDF, tiled on two A4 sheet;
Instructions
------------
If you want to make embroidered pockets it's easiest to do on the fabric
before cutting it: mark the outline and slit of the pocket and embroider
leaving a clear space around those markings of at least half the width
of your binding.
Cut the pattern four times in your fabric. If you need to protect the
back of the fabric (e.g. because it is embroidered and the contents may
catch on it) also cut the pattern four times in lining.
If using a lining, lay it on the wrong side of each panel, baste it and
from now on treat as one.
Cut the slit on two of the panels, bind both sides.
.. figure:: 0101-binding_slit_front.jpg
:align: center
If your binding has raw edges, align one raw edge of the binding to the
raw edge of the slit, right sides together, backstitch on the fold of
the binding
.. figure:: 0102-binding_slit_back.jpg
:align: center
press towards the wrong side and hemstitch down.
If your binding is a tape with finished edges, fold it in half, pin it
over the raw edge of the slit, applique stitch on the right side and
then hemstitch the wrong side.
.. figure:: 0105-slit_end_reinforcements.jpg
:align: center
Cut four small patches (two per pocket) from the scraps of fabric, fold
their edges towards the wrong side and sew it at the end of the slit on
both sides to reinforce the weak point,
.. figure:: 0106-slit_front_reinforcement.jpg
:align: center
applique stitching to the rigth side
.. figure:: 0106-slit_back_reinforcement.jpg
:align: center
and hemstitching to the wrong.
.. figure:: 0107-front_and_back.jpg
:align: center
Put one panel with a slit on top of a panel with no slit, wrong sides
together, backstitch all around it at 5 mm from the edge.
.. figure:: 0108-binding_edges.jpg
:align: center
Bind the side and bottom edges using the same tecnique used for the
slit, carefully following the curves at the bottom.
Cut a piece of tape long enough to go around the waist and be tied, pin
the top edge of the two pockets on top of it so that they are
symmetrical and lie at the right position for the slits in your skirts.
.. tip::
If you're making more than one pair of pockets, put them at different
distances from the front, so that you can choose the ones that fit
better with the line of each skirt you're wearing.
.. figure:: 0110-sewing_pockets_to_tape.jpg
:align: center
If using tape with raw edges, first sew the pockets to the tape, right
sides together,
.. figure:: 0111-closing_tape_edge.jpg
:align: center
then fold down the tape and whipstitch it closed starting from one end
.. figure:: 0112-closing_tape_back_pocket.jpg
:align: center
and continuing on the back of the pockets, and to the other end.
If using finished tape, hemstitch the tape to the pocket at the bottom
edge of the tape.
Put another piece of tape on top of just the front of each pocket,
folding down the raw edges, applique stitch it to the pocket and to the
tape at the sides; whipstitch the two tapes at the top, enclosing the
raw edge of the pocket.
Fold down the ends of the long tape, hemstitch them down to finish even
these raw edges.
Your pair of pockets is done!
Gallery
-------
.. figure:: pair_of_pockets_cats.jpg
:align: center
Simple DITTE cotton pockets with tape binding and screenprinted cat
siluettes.
.. figure:: tactical_front.jpg
:align: center
As a sort-of-joke, I also made a pocket using technical fabric, a
water repellent zipper and MOLLE webbing, sewn like on the
:doc:`../modular_backpack_base/index`.
.. figure:: tactical_back.jpg
:align: center
The back of the same pocket, with two additional belt loops to be
able to wear it also when not using a MOLLE base.
.. figure:: jättevallmo_pockets.jpg
:align: center
A pair of pockets made out of leftovers of a JÄTTEVALLMO duvet cover.
.. _pockets_see_also:
See Also
--------
In the 2020s, pockets are IN, at least in the online sewing community:
this is a small selection of people who made their own pockets.
* `Make your own Pocket (Victoria and Albert Museum)
`_
* `Pair of pockets (Miss Hendrie's Workbook)
`_
* `Making an Embroidered Pocket (Tea in a Teacup)
`_
* `If they can't fit pockets in our clothes, we'll bring back POCKETS AS
FASHION (Bernadette Banners)
`_
* `Linen pocket (Josefin Waltin spinner)
`_