From 7c0652a74a79ecf39517f08bba5a4fb8d1d65c8b Mon Sep 17 00:00:00 2001 From: Elena ``of Valhalla'' Grandi Date: Tue, 30 Apr 2024 18:05:37 +0200 Subject: More instructions --- .../bookbinding/cartonnage/ink_drawers/index.rst | 45 ++++++++++++++++++++++ 1 file changed, 45 insertions(+) (limited to 'source/bookbinding') diff --git a/source/bookbinding/cartonnage/ink_drawers/index.rst b/source/bookbinding/cartonnage/ink_drawers/index.rst index 6058b37..33f9dce 100644 --- a/source/bookbinding/cartonnage/ink_drawers/index.rst +++ b/source/bookbinding/cartonnage/ink_drawers/index.rst @@ -54,6 +54,8 @@ then the two lateral sides and finally the front. +Optionally sand the corners to smoothen the joins. + Spread PVA on the bookcloth for the sides, put the drawer so that it is centered on the shorter side and wrap the bookcloth all around the drawer, keeping the join as close as possible to one of the back @@ -79,11 +81,54 @@ Spread PVA on the bottom lining, put it in the bottom of the drawer. Assemble the optional divider inserting each piece in the slots of three other pieces. +Insert it in the drawer, trimming up to half a mm from the side edges if +necessary. + Repeat for all other drawers. Structure ^^^^^^^^^ +Mark the center line on the bottom plate. + +Using contact glue, attach two sides to the center of the bottom plate; + +then the two backs; + +and finally the two outer sides. + +For each remaining drawer space, use contact glue to attach a side to a +square plate; + +then the back; + +and finally the other side. + +Again with contact glue, attach all drawers spaces on top of the ones +already on the base. + +And one last time with contact glue, attach the top plate to the two top +drawer spaces. + +Optionally sand every place where two cardboard pieces are joined to +smoothen it. + +Spread PVA on the bookcloth pieces for the horizontal separators, glue +them in place. + +Spread PVA on the bookcloth piece for the central vertical column, glue +it in place. + +Spread PVA on the bookcloth piece that wraps around the body, glue it in +place leaving the joint on the bottom, and aligning the front at 2 cm +from the paper edge; + +clip the front edge at every separator and glue the front edge towards +the inside of the structure; + +and then clip the corners on the back, and glue the bookcloth flat. + +Put PVA on the bookcloth piece for the back, glue it in place. See also -------- -- cgit v1.2.3